Publications

Yost, CR; Minnis, P; Sun-Mack, S; Smith, WL; Trepte, QZ (2023). VIIRS Edition 1 Cloud Properties for CERES, Part 2: Evaluation with CALIPSO. REMOTE SENSING, 15(5), 1349.

Abstract
The decades-long Clouds and Earth's Radiant Energy System (CERES) Project includes both cloud and radiation measurements from instruments on the Aqua, Terra, and Suomi National Polar-orbiting Partnership (SNPP) satellites. To build a reliable long-term climate data record, it is important to determine the accuracies of the parameters retrieved from the sensors on each satellite. Cloud amount, phase, and top height derived from radiances taken by the Visible Infrared Imaging Radiometer Suite (VIIRS) on the SNPP are evaluated relative to the same quantities determined from measurements by the Cloud-Aerosol Lidar with Orthogonal Polarization (CALIOP) on the Cloud Aerosol Lidar and Infrared Pathfinder Satellite Observation (CALIPSO) spacecraft. The accuracies of the VIIRS cloud fractions are found to be as good as or better than those for the CERES amounts determined from Aqua MODerate-resolution Imaging Spectroradiometer (MODIS) data and for cloud fractions estimated by two other operational algorithms. Sensitivities of cloud fraction bias to CALIOP resolution, matching time window, and viewing zenith angle are examined. VIIRS cloud phase biases are slightly greater than their CERES MODIS counterparts. A majority of cloud phase errors are due to multilayer clouds during the daytime and supercooled liquid water clouds at night. CERES VIIRS cloud-top height biases are similar to those from CERES MODIS, except for ice clouds, which are smaller than those from CERES MODIS. CERES VIIRS cloud phase and top height uncertainties overall are very similar to or better than several operational algorithms, but fail to match the accuracies of experimental machine learning techniques. The greatest errors occur for multilayered clouds and clouds with phase misclassification. Cloud top heights can be improved by relaxing tropopause constraints, improving lapse-rate to model temperature profiles, and accounting for multilayer clouds. Other suggestions for improving the retrievals are also discussed.

DOI:
10.3390/rs15051349

ISSN:
2072-4292